Installation

• Place the machine on a flat, stable surface away from direct sunlight.
• Ensure at least 15 cm of clearance around the unit for proper ventilation.
• Check that the power supply matches the machine’s rated voltage.
• Use a power cable with a cross-section of 1.5–2.25 mm².
• Connect the machine to a grounded socket with proper fusing.
• Slightly incline the front lower than the back to allow drainage through the hose.

• Pour the beverage into the container without exceeding the maximum level.
• Do not fill liquids over 35°C to maintain cooling performance.
• Plug the machine into a grounded socket.
• Switch to “Cooling” mode and start the stirrer or dispenser.
• When cooled, gently press the spout lever to pour the drink.
• The compressor cycles automatically based on temperature.
• After a power interruption, wait 5 minutes before restarting.

• Plug into a grounded socket.
• Switch to “Heating” mode and activate the stirrer.
• Fill with at least 6L of beverage to prevent dry heating.
• When heated, press the lever to dispense.
• The heater cycles automatically with temperature changes.
• Clean the containers daily to maintain hygiene.